Add to Cart
Our Price: $39.95
Product Code: A125
A light duty swivel with lubricating ball bearing for hanging tyres on wood beams. It will turn 360 Degrees with less tangling or wrapping chain. The plate is 12.3825cm x 6.35cm with two 7.62cm holes that are 7.62cm center to center. This swivel is better made and has fuller motion than other look a-likes. It hangs down 12.065cm from pipe. You can use the H140 – H150 or the H172 for this. This product should last 2 years in harsh conditions and up to 5 years in optimal conditions. Some conditions may require replacement sooner. Tensile strength 5000 lbs.
Installation: Grease the Tyre S ...
Read more
A light duty swivel with lubricating ball bearing for hanging tyres on wood beams. It will turn 360 Degrees with less tangling or wrapping chain. The plate is 12.3825cm x 6.35cm with two 7.62cm holes that are 7.62cm center to center. This swivel is better made and has fuller motion than other look a-likes. It hangs down 12.065cm from pipe. You can use the H140 – H150 or the H172 for this. This product should last 2 years in harsh conditions and up to 5 years in optimal conditions. Some conditions may require replacement sooner. Tensile strength 5000 lbs.
Installation: Grease the Tyre Swivel before using. Tyre Swivel must be installed in a bay without any other components. For tyre swings, extend surfacing in a circle whose radius is equal to the height of the suspending chain or rope, plus 182.88cm in all directions. Only use this tyre swivel in residential settings. Place tyre swivel on wood beam and mark holes with pencil or pen on wood. Drill two 7.62cm holes. Then, bolt tyre swivel to wood beam with 7.62cm bolts with the length depending on thickness of the wood, plus two flat washers, one on top and one on the bottom of the bolts and secure with a 7.62cm nylock nut. (Bolt, washers and nuts are not included.) Put bolts and washers through beam so that nuts are on the bottom of top beam, and so that the bolt is attached with no more than two thread showing beyond the nut. This will prevent a protrusion on the top beam. You will need to use S-hooks or H shackles from the chain to the swivel. Make sure the S-hooks are closed to within .04 to meet ASTM safety standards. To do this you will need to use our S-hook pliers or a regular pair of channel lock pliers. Close according to Fig A1.19 for Fastening Devices. WARNING: Once the S-hooks have been opened they will have to be replaced to avoid injuries from coming open and/or breaking. Make sure that if you are using shackles they are also tightened correctly. No bolts should protrude over two threads past its nut.
Safe Use: This is for children 2 - 12 years old only. Adults should supervise children at all times. Do not allow children to use unsafely. Do not allow it to be used if damaged.
Maintenance: Do the following to reduce the chance of serious injuries. At beginning and end of each play season and once a month during play season, check for rusty or worn chain. Carefully check hole around fastener to look for wear. Check for vandalism. Check to make sure s hooks and/ or H-shackles are closed properly. Check spinning action and make sure there is no binding, and using a grease gun put a sufficient amount of standard grease into the swivel through the grease fitting. You will see the grease come out when it is full. We have used a McKay Molybdenum Disulfide grease cartridge, but any standard grease cartridge from any auto part store should be sufficient. Make sure all nuts and bolts are secure and not worn. Look for loose parts, cracks in metal or rust. Replace parts necessary for safe use.
Tell a friend about this product
Ask question about this product
Add to Cart